Hydro-logic EvolutionRO 1000 Instrukcja Użytkownika

Installation & Maintenance Manual

Tested @ 77F and 500 PPM source water. Flow rates will vary depending on source water, temperature and PPM’s.IMPORTANT NOTE:The flow rate of product wa

TO CARE FOR THE RO SYSTEMThe components of the RO system are designed to function with minimal maintenance. However, the membrane elements and pre-filt

If changing membrane elements:7. Remove membrane sumps. Remove and discard used a. elements.Remove new elements from packaging.b. CAUTION: Elements

Performance SpecificationsMinimum and Maximum Operating ConditionsCondition Minimum MaximumInlet Pressure 40 psi (2.76 bar) 80 psi (5.52 bar)

TROUBLESHOOTINGIssue Possible Cause Corrective ActionLow product flow rateLow driving pressure.Increase feed pressure. Consider pump for low pressure l

NOTES:________________________________________________________________________________________________________________________________________________

GL4000442 RevA

NOTES:________________________________________________________________________________________________________________________________________________

EVOLUTION-RO1000 Reverse Osmosis SystemInstallation and Maintenance ManualSAFETY GUIDES Read and follow all steps and guides carefully before installi

THE BASIC REVERSE OSMOSIS SYSTEM cont.COMPLETEMANIFOLDPN 23062 (1 pc)SUPPORTLEG/SUMP WRENCHPN 23063 (1 pc)SUMP(FILTERHOUSING)& O-RINGSUMPPN 23115

LOCATION OF SYSTEMThe reverse osmosis system can be installed under or near a sink or any other water supply. The RO assembly can be placed on the sin

THE BASIC REVERSE OSMOSIS SYSTEM cont.1.5" Air Gap RequiredInlet-1/2" WhiteDrain - 3/8" Black Purified Water - 3/8" BlueFeed Water

INSTALLATION STEP 1: Install cold water supply fitting. Use either the included garden hose connector or any of the other optional feed fittings. STEP

NOTE: Make sure the tubing is pushed past the O-rings for a secure fit. Also, when replacing any tubing, cut tubing back ~1/4

Recommended Placement PositionsThe RO assembly should be positioned in one of two ways. The first position is with the unit standing upright using the